- Home
- About
Cars - Line- Lnh - 20
- Lnh - LE-20/30
- Valentine 1 remote
- Smart-Mute
Motobikes - Line- Moto-Flash
- Moto-Flash +
Tools- Laser Tester
- Contact
- Online store
- Local distributors
- Photo album
Lnh-20,25,27 Installation
Mechanical:
Installing the system may require taking down the bumper.
The width of the Lnh unit is designed to fit the M-20 Extreme units,
just screw the M-20 units screws into the forks and level the units so
that they are facing front.
Use the aluminum brackets provided to mount the Lnh into the bumper.
Please look at the drawing to make sure that the Lnh units will fit inside your bumper.
Size:
Depth: 1 5/8 inch
Width: 6 ½ inch
Height with M-20 units installed: 5 ½ inches (minimum), 6 ½ inches (fully extended)
Electrical
Plug the two Lnh units (standard Rj-45 connector), the LEDs and the switch (standard Rj-11 connector) into the interface box. All you need now is to connect the interface box to the car's 12V terminals (via the car's start switch). Mount Both LEDs into one of your provision for switches. Locate the switch in an accessible place.
Kit includes:
2 - Lnh units + cables
1 - Interface box (Hub)+ cable
1 - Switch + cable
1 - LEDs display (green+red) + cable
1 - Brackets and screws installation kit
1 - Instructions manual
